JK制服扒开粉嫩的小缝喷白浆,JK制服扒开粉嫩的小缝喷白浆,嗯啊99视频日本,久久精品99久久香蕉国产 ,国产美女AV,中文字幕第一页在线视频观看 ,久久精品国产首页027007,亚洲性线免费观看视频,在线不卡高清播放AV网站,亚洲第一在线视频,国产妇乱子伦视频免费,久久一本到亚洲综合一本到88,又粗又硬又黄又爽免费的视频在线播放,男女过程很爽的视频网站,一本本道久久99,18女下面流水无遮盖视频,好爽好大再深点高H免费视频

Since it is more difficult than general cutting, the cutting fluid of such materials must also have different properties, and it is hoped that it will be beneficial to reduce the cutting difficulty. Among the difficult-to-cut materials, some have higher hardness, reaching 65-70HRC; some have very low thermal conductivity, so that the heat in the cutting zone cannot be conducted quickly; others are very high in hardness and strength, and the material is chemically active, elastic mode. The extremely small amount and large elastic recovery and large elongation rate all cause cutting difficulties.

When cutting various difficult-to-cut materials, select the appropriate cutting fluid according to the respective properties, cutting characteristics and processing stages of the material to be cut. The purpose is to improve the machinability of difficult-to-cut materials to achieve the purpose of processing. Commonly used cutting fluids include aqueous solution, common emulsion, extreme pressure emulsion, mineral oil, vegetable oil, animal oil, extreme pressure cutting oil, etc. Various cutting fluids will have different effects on the above materials.
For high-strength steel, in addition to the common cutting fluid and extreme pressure cutting fluid, it can also use soybean oil or rapeseed oil as the tapping cutting fluid, which can also have good results.